Garage Door Installation Instructions

The installation instructions for garage doors outlined here are only general, and are not a complete set of instructions. For full guidance, you can review your Installation Manual. But it is not as hard to mount a garage door as some might imagine. It requires the ability to follow and take logical steps in order. Measurements are the first order of business. Get the facts about Garage Door Spring Repair Near Me.

Before you can get started, you will need to have some exact measurements. These will help determine the size of the door you need and should be written down so that you will not forget it. Take first the door opening height and width. This will give you the starting point for your figures and, once again, will represent your door size.

Finding your’ side-room’ is the next move. This is the space on the same side, from the side of your door to the garage wall. For your regular extension spring and torsion spring, you vertical line, will require at least 3-3/4 from the foot. Then you’ll need to have 5-1/2 for the extension season.

Your next test is to assess your’ head-room.’ This is the amount of space that will start at the top of the door up to the ceiling. In this case, you’ll need 10, and 12 for the torsion spring for an extension spring. If you’re running into a situation where you’ve little headroom, then special equipment is designed just for that occasion. If you intend on installing a garage door opener you will need more headroom.

Now it’s time to get the’ back-room’ numbers. This will be the gap between the garage door that opens up all the way to the garage wall backwards. This should add up to whatever your door height is, plus an additional eightteen inches. And just like above, if you’re planning on putting in a garage door opener, you’ll need more space.

You can now get the door opening ready for installation when you have your measurements taken and written down. You should have a frame of 2×6 wood jambs on the inside of the door opening. This wood will match the height you’ve measured just a little earlier in the headroom. If old should be replaced with fresh, they should be level and plumb, and the wood. Make sure that when installing your new door, if there are any bolts, the heads are flush down and don’t stick out where they might get in your way.

Now we’re getting into the pieces. The segment at the bottom gets first prepared. Get your equipment, and put it on the garage floor in groups. Add your weather stripping to segment below. On top of saw horses this is best done. It is where you have to follow the instructions to a “T” because not every garage door is exactly the same. But this is the position where the lift cable as well as the hinges and the reinforcement strut get connected.